Berkeley DB Reference Guide:
Debugging Applications

PrevRefNext

Compile-time configuration

There are three compile-time configuration options that assist in debugging Berkeley DB and Berkeley DB applications:

--enable-debug
If you want to build Berkeley DB with -g as the C and C++ compiler flag, enter --enable-debug as an argument to configure. This will create Berkeley DB with debugging symbols, as well as load various Berkeley DB routines that can be called directly from a debugger to display database page content, cursor queues, and so forth. (Note that the -O optimization flag will still be specified. To compile with only the -g, explicitly set the CFLAGS environment variable before configuring.)

--enable-diagnostic
If you want to build Berkeley DB with debugging run-time sanity checks and with DIAGNOSTIC #defined during compilation, enter --enable-diagnostic as an argument to configure. This will cause a number of special checks to be performed when Berkeley DB is running. This flag should not be defined when configuring to build production binaries because it degrades performance.

--enable-umrw
When compiling Berkeley DB for use in run-time memory consistency checkers (in particular, programs that look for reads and writes of uninitialized memory), use --enable-umrw as an argument to configure. This guarantees, among other things, that Berkeley DB will completely initialize allocated pages rather than initializing only the minimum necessary amount.

PrevRefNext

Copyright (c) 1996-2003 Sleepycat Software, Inc. - All rights reserved.